If your inverter generator runs into problems along the way, there are always ways to fix the issues to ensure the smooth running of the generator. The WEN 56235i 2350-Watt generator is not an exception when experiencing problems. The best thing is the presence of a WEN 56235i 2350-Watt troubleshooting guide in the user manual. It is advisable to avoid using the inverter generator if one realizes there are specific problems. That minimizes the risk of expanding the issue.
WEN 56235i Major Problems, Possible Cause, and Solutions
Many WEN generator problems have specific causes and are issues that one can resolve quickly. The best thing about WEN 2350-Watt is that you don’t have to be an expert to be able to fix the generator’s problems. However, if the user cannot handle the situation, it is always good to ask an expert or professional for help.
1. The engine fails to start
The WEN 56235i 2350-Watt troubleshooting guide shows that if the generator’s engine fails to start, the engine switch might be in the off position. Set the button to ON if it’s OFF. Open choke may also cause the engine not to kick off, and closing them will ensure it starts. In addition, another leading cause of engine failure is low fuel level.
When the fuel is out, the engine will automatically shut down and will not start the next time you try powering it up. In that case, draining the gas in the carburetor is necessary, and then refilling the fuel tank with fresh gas. If the spark plug is damaged or dirty, the engine will fail. Always clean and change the spark plug to deal with this issue. Always change and refill the oil and unclog the carburetor to prevent engine failure.
2. Lack of power output
In some cases, the engine may operate flawlessly, but there is no power output. That means the problem does not come from the engine since a faulty engine will not start. Misconnecting the cords may cause the absence of power output. Ensure that you plug in the correct cables to their respective ports. Suppose the wires still don’t work even after plugging in the right way; check for cord damage and replace it for it to work. Lack of power output may also result from tripped Circuit breaker if there is too much load. Remove all the loads and reset the circuit breaker to get power output.
3. The generator does not support electronics
One might realize that the WEN 2350-Watt inverter generator runs perfectly; however, it does not support the electronics plugged in. If this happens, there is probably a device with a short circuit in the generator. The solution to the problem due to this cause is unplugging any electronics with a short circuit. A dirty air filter may also cause the lack of electronic support by the generator. If faulty, cleaning or changing the air filter will allow the inverter generator to support the electronics perfectly. General generator overload is the leading cause of generators not supporting devices. To deal with the issue of overload, follow the following steps;
- Switch off all electronics
- Unplug the electronics from the inverter generator
- Switch off the inverter generator
- Let it remain inactive for a few minutes before restarting
- Plug back a few electronics this time
Conclusion
WEN 56235i 2350-Watt inverter generator is among the best inverter generator you could ever find on the market. Therefore, if you experience any problem with the generator, it is not a quality issue. One must check all the generator parts to ensure there are no faulty parts. Replace defective parts and clean the ones dirty to ensure the generator runs well. The WEN 56235i 2350-Watt troubleshooting guide will aid in determining the problems and provide necessary solutions.